-
-
-
-
PRODUCTS
-
GYX-L02 Height Measuring Device
GYX-L02 Height Measuring Device
[Specification] : 248*243*3070mm
[Safe Usage Scope]: 3300x3300 (mm)
[Instructions for Use]: Stand beneath the height‑measuring device, with your feet shoulder-width apart and your knees slightly bent in a half‑squat position. Swing both arms from back to front and upward in a bending motion, coordinating this with a knee extension to propel your body into the air.
[Main Features]: Enhance lower-body muscle strength and effectively improve lower-body explosive power.
Category:
Product Description
[Main Technical Parameters]:
◆ Direct‑buried type: the main upright posts are made of national‑standard steel pipes with a diameter of 114 mm and a wall thickness of 3 mm; the main frame’s support tubes are made of national‑standard steel pipes measuring 25 × 50 mm with a wall thickness of 3 mm.
◆ The elevation plate of the height‑measuring device is made of 304 stainless steel, with a thickness of 1 mm, and is securely and reliably fastened to the main frame using Ø4 pop rivets.
◆ The embedding depth of the equipment upright shall be no less than 600 mm, and the underground dimensions shall be no less than 500 × 500 × 600 mm.
◆ The equipment nameplate is made of fully stainless steel with a corrosion‑resistant finish, measures 220 × 80 mm, features robust rivets, and has edges that fit tightly against the upright posts to prevent snagging or injury.
◆ The top of the column is sealed with a flat cap to prevent rainwater from entering.
◆ The equipment has undergone relevant static load and stability tests in accordance with the GB 19272-2011 standard and complies with the standard’s requirements.
◆ The entire machine has no snagging, crushing points, shearing points, or pinching hazards; all apertures and gaps comply with the GB 19272-2011 standard.
◆ The components are cut to size using a fully automatic CNC sawing machine, ensuring high efficiency and precise positioning. The pipe‑bending process employs a CNC pipe‑bending machine, delivering accurate angles and an aesthetically pleasing finish. Prior to welding, the parts undergo degreasing to eliminate any residual oil or contaminants from the surface. Welding is performed with a CO₂‑shielded arc welder in conjunction with a mixed‑gas shielding process, resulting in clean, smooth welds that require no post‑weld grinding. A dust‑collection and treatment system is also installed to purify workshop air and safeguard workers’ health. Surface treatment utilizes shot blasting, achieving thorough rust removal, increasing the effective surface area of the workpiece, and enhancing the adhesion of the powder coating. The exterior surface is coated with a green, environmentally friendly electrostatic powder finish, applied using imported electrostatic spraying equipment that ensures uniform powder distribution and strong adhesion. The coating is resistant to acids and alkalis, withstands high humidity and heat, resists aging and corrosion, and maintains an attractive appearance—making it ideal for humid conditions and areas prone to acid rain. The paint formulation contains no toxic elements, and the powder recovery system employs a cyclone‑type centrifugal separator, achieving a recovery rate of up to 98.6%. This not only conserves powder and reduces dust pollution but also offers convenient operation while promoting energy efficiency and environmental protection.
◆ The equipment is packaged in a double-layer system: thickened bubble wrap inside and strapping tape on the outside, effectively protecting it from impacts during transit and ensuring it arrives undamaged.
Keywords:
Related products
Online Exhibition Hall
Follow us
Scan to access the WeChat official account.
Contact us
Add：Sanhe Economic and Technological Development Zone, 50 km east of Jianguomen, Beijing
Tel：+86-316-3722333 +86-316-3722971
Fax：+86-316-37233038
E-mail：shguiyuxingty@sina.com
